Tel: +86 13921985178

E-mail: Annyzhao2000@hotmail.com

Home > News > Content
Tube Bending Machine Operation Precautions
- Dec 27, 2018 -

1. Before the tube bending machine is operated, check whether the lubrication point of the pipe bending machine is lack of oil, whether the movement mechanism is loose, and whether the safety protection device is reliable, and can only be operated after confirmation;

2. Adjust the required position and angle of the parts;

3. Start the tube bending machine oil pump, whether the system pressure is kept within the specified range. If it is high, it will damage the hydraulic components and waste power. If it is too low, it will affect the work;

4. The clamping mold clamping cylinder can clamp the iron pipe;

5. The normal operation is to put the workpiece into the bending mold, and the front end is in contact with the positioning, and the foot switch is pressed to complete;

6. When operating the tube bending machine, the thought should be concentrated, it is forbidden to put the hand or other articles into the working area. If an emergency occurs, press the stop button, then switch the turn and twist switch to the manual position, use manual reset, if failure occurs, report for repair in time;

7. Finally, after the work, cut off the power supply, do a good job such as clean lubrication.