bender electric The structure of the bender electric is mainly powered by a motor, and a hydraulic pump is driven by the --stage shifting, and the hydraulic cylinder is used to work for the top bending. The whole machine uses angle steel as the skeleton, the upper part is the workbench; the...
The structure of the bender electric is mainly powered by a motor, and a hydraulic pump is driven by the --stage shifting, and the hydraulic cylinder is used to work for the top bending. The whole machine uses angle steel as the skeleton, the upper part is the workbench; the lower part is the power unit and the fuel tank oil pump. The workbench is made up of two 8 mm thick iron plates on the top of the frame, and the top of the table is opened with eye holes for various sizes of sheaves. In the fashion of the pipe, the pipe mold and the sheave are driven, and the oil valve is actuated to drive the electric door, so that the top bend can be performed. The mechanically mounted limit switch can stop itself as long as the limit switch is fixed when bending the same bend. After the machine is stopped, the spring is lifted off by itself.
This machine is mainly used for processing thick and thick iron pipes in building hydropower installation projects. It can bend in various specifications of 90° or less, and can also bend various specifications of the ingot bend (commonly known as the nose nose bend) and the light fork. The bending method is extremely simple. When bending, just put a good mold, put the iron pipe, and turn on the button to bend it quickly.
1. Before operation, carefully check whether the various parts of the pipe bending machine are normal, whether the electrical operation equipment is missing, whether the smooth system is dredged, and the things such as things, measuring tools and other debris and corner scraps are placed in the table and the surrounding area; secondly, do not need to operate separately. Above the person, the feeding, manipulation scale accuracy and reclaiming.
2. According to the thickness of the cutting plate of the rule, adjust the gap of the scissors of the pipe bending machine to avoid the two different standards of cutting together. The sheets of different raw materials should not be cut by the stacking, and the cut sheet should be requested. Flat, it is forbidden to cut narrower sheets that cannot be compressed.
3, the belt, flywheel, gear and shaft and other moving parts of the pipe bending machine are necessary equipment protective cover; the flywheel, gear, shaft, tape and other movements of the pipe bending machine should be equipped with a protective cover.
4, can not cut the quenching and over-fire data, to avoid the ability to allow cutting beyond the shearing machine; place the gate operation, to avoid the operator's hand into the falling area of the scissors, the work is prohibited to pick up the ground scrap, so as not to be dropped Hit.
5, the fingers of the operation of the bending machine personnel should be kept at least 200mm away from the scissors, and the protection device can be blocked from the operator's eyes without seeing the cut parts. The waste generated after the operation is angular and the operator should remove it in time to avoid being stabbed and cut.
Maximum bending pipe diameter x thickness (steel)
Maximum bending radius(1)
Minimum bending radius(2)
According to the pipe diameter
The largest bending angle
Maximum feeding length(3)
Direct feeding/Clamping feeding
Working speed Rotary speed
Accuracy Rotary precision
Information inputting method
1.Axis(X Y Z) 2.Working value(Y B C)
(more than 3 axis)
Power of ratary servo motor(5)
Power of feeding servo motor(6)
Max ellbow bending pipe
Max storable sections
Max hydraulic pressure